Choosing Replacement Belt For Treadmill Damages

The part most prone to wear and tear is the belt for treadmill. It is therefore important for you to know how to properly maintain it and to know if there's a need to replace it. How do you check signs of damages?

The two most important parts of the treadmill are the belt and the deck. If the belt is not properly taken cared of, the deck's mechanical operation will also get affected.

It's very important to keep the belt for treadmill in good condition especially if it's frequently used everyday. You will know if your belt needs replacement if you notice these items.

- When your belt has curls on its edges.

- When the speed slows down the moment you step on the deck.

- There obvious grooves appear on your treadmill belt.

Replace the belt when it looks generally worn-out. Otherwise, it may only need lubrication or waxing to keep it functional.

If one or two signs of damages are present, you may have to replace your belt. If you do not have the instruction manual, here are the basic instructions.

Removing the belt

- Unplug the treadmill. Make sure your treadmill is not connected to a power supply.

- Look for the hood of the treadmill's motor and remove it.

- Prepare the removal of the rear roller by loosening the screws on both sides at the rear end. These are the same screws affecting the tension of the belt.

- The same procedure applies to the front roller. Incline the board if the screws are not accessible.

- Take out the front and rear rollers once the screws are removed.

- Take the belt out.

Replacing the belt for treadmill

- Lay the new belt and deck together. Slide the belt over the deck and align.

- Install the rollers and fasten the deck to the frame properly and securely.

- The next step is to fasten the belt and deck together with the screws. You may need to adjust the deck to get the screws in.

- Slide the belt in through the rear roller by pulling it to the rear end.

- Adjust the screws a bit to hold the parts together.

- Replace the drive motor belt over the drive gear by sliding the front roller inside the belt.

- Fix the belt snuggly onto the deck by tightening the screws on the front and rear rollers.

- You may need to adjust it now that the belt is already in place. The adjustment concept is done by changing the speed to test the tightness and feel of your belt.

It's best not to do belt replacement yourself if you have not tried this procedure before. Seek help from someone who has more experience in replacing a belt for treadmill.

Article Directory: http://www.article-tree.com

Apply a treadmill belt lubricant to maintain the belt for treadmill. Know more tips online.

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated